Set your Crush It to match the stage time, and when the RO starts his timer, start yours simultaneously. Visually (and audibly) monitor the remaining time in your run, allowing you to gauge when to speed up or slow down. Remove the unknown with the MDT Crush It – Stage Timer.
MDT Crush It – Stage Timer
£295.00
CUSTOMIZE TO YOUR PREFERENCE
Ready to use out-of-the-box for a preset 2-minute stage, or use Custom Mode to fully customize every aspect of your timer; time, various alert points throughout, tone type, volume, starting tones, and ending tones. Also choose between graphics mode, or digits mode to change how your time is displayed.
TRAIN EFFICIENTLY
Learn how to use your time efficiently and see where you can speed up. Use the stopwatch mode to see how long you’re taking at any point during a stage.
KEEP YOUR EYE ON THE TARGET
Choose when the timer will beep, what the beep sounds like, how loud each beep is, and how many times it will beep each time, letting you know exactly how much time you have left without even having to look at it.
ALWAYS ACCESSIBLE
Mount on any section of Picatinny rail with the included MV3 Inverted 90 Mount so that it’s always in view and easily accessible.
- RIFLE MOUNTED FOR EASY ACCESS
- AUTO POWER OFF TO INCREASE BATTERY LIFE
- VISIBLE IN ALL LIGHTING CONDITIONS
- WEATHER RESISTANT
- MOUNT IN ANY ORIENTATION
- CONTROL VOLUME, INTERVAL, TIMING, & TONE
- SILENT MODE FOR VISUALS ONLY
- BASIC MODE READY TO USE OUT-OF-THE-BOX
- CUSTOM MODE FOR EXTENSIVE CUSTOMIZATION
- STOPWATCH MODE FOR TRAINING & STAGE SETUP
- GRAPHICS & DIGITS MODES
- SAVES ALL CUSTOMIZATIONS
- COMPATIBLE WITH 2.5MM PRESSURE SWITCH
- LASTS FOR 200 2-MINUTE STAGES ON AVERAGE
4 in stock (can be backordered)
